MilwDave's latest activity

I totally appreciate the kudos, it's extremely flattering... Flattery is like chewing gum; it's good while you're chewing it.. you...

It looks like it’s just another factory sponsored custom bike.

The modes are still there. I’m in Rock mode unless there’s water on the ground, so I don’t have as much to say about the other two...

Thanks for the honest assessment Dave ... I have been kicking the idea of doing it for a while ... but I am contemplating diminishing...

And who was that?

The price of entry is substantial, for sure. And is it worth it? I guess that depends on what $1000 means to anyone pondering the...

Me to..... will notice more difference with a new jacket and maybe taking the wife out for a nice meal..... their r ninet tune is...

Same here ... isn't it nice 😁

It definitely does not have the impact the good DynoJet tunes I have in my Indians. But it does offer subtle improvements in fueling...

I'm about ready to order the Bren tune for my 23 Anniversary model. Just had the 600 mile service. Just wanted to check in with the...

LOL, other than my buddy’s custom R18 bobber I have not seen another R18 on the road here in Milwaukee.

The Roctane directionals are the one I plan to get, just have to wait till my wife is not paying attention to my R18 spending any more 😂

I would think powder coating your existing signals would be far less expensive.

Any two wire signals should work. I have Kellerman Atto lights on my bobber and there are no issues.

Or you can weld up the holes if you remove it completely as I did.