Recent content by bmg50

I'm going to attempt an install of the light bar, lights, brackets and all parts for the aux lights on my stock 2021 R18 with cruise, has anyone DYI'd it as of yet, outside of their dealer? I do not have this switch yet, the only part I don't have but was curious if anyone's done their own install.

If it helps anyone, here is a full parts list for the windshield and needed hardware and parts as an add on assembly to the R18. Low windshield, upper and lower mounting frames with aux. lighting in black.

Carlos, are you satisfied with results/sound/performance after your installation?

In Michigan, gets very winter like here too. Mines on a piece of commercial carpet, keeps a layer between the cold cement and tires. Definitely will wheel it out the garage and start it up once a month or so, therapy for me to hear it run and good to turn those tires too. I’ll ride a street lap...

DK lower plate install sheet, for what it’s worth 😐

Thank you admins for hosting this forum! Only observation is many similar or random topics, not an easy task to wrangle. Keep up the great work. Spam patrol alone is the plague of most forums, you’re doing good fighting all that. This is a great site to keep us updated, swap ideas, discuss...

https://www.amazon.com/dp/B00Z3Y95LI/ref=cm_sw_r_sms_api_glt_fabc_G64RQS1YT2SXZWM9W5GP?_encoding=UTF8&psc=1 this was the link to the harder to find M12x110mm bolts, picture not accurate.

sure, …glad to, Complete List: M10x30mm Qty. 2 (cross tube bolts) M10x45mm Qty. 1 (top mount bolt) M10x65mm Qty. 2 (low mount bolts) M10 stainless flat washers Qty. 5 M12x40mm Qty. 4 (main guard tube bolts) M12x110mm Qty. 2 (frame/engine plate Mt. bolts) M12 stainless flat washers Qty. 6...

very happy with the quality of the parts, feels solid, fitment is tight and all went together with no modifications needed.

final results, took my time, after a couple hours, done!

bottom plate installed

added the black bottom plate at this time too

using factory wire clip, new horn fits in perfect,

if you go with 12pt metric bolts, these 10 and 12mm ratchet end wrenches are needed, once all bars are in place time to snug down tight.