Pinstriping on FE

[OzR18]

I know this has been visited a few times in various contexts, but I'm hoping to get quite specific here.

I'm wanting to get some matching white on black pinstriping done on my FE - nothing too much, but I'd like it to match as close as I can to what's already on the tank & fenders.

Acknowledging that they're done by hand, which brings with it variations, has anyone run a set of callipers over their bike to get a rough measure of what width the lines and gap are?

I'm asking because I don't have a set of such callipers.

Many thanks.

 

[VARG]

I checked close as I could visually and got 3mm, 3mm, 5mm. Compared rear fender and tank on my 2021 R18 FE and they were same.

 

[OzR18]

I checked close as I could visually and got 3mm, 3mm, 5mm. Compared rear fender and tank on my 2021 R18 FE and they were same.

Thank you - much appreciated

 

[enzo5000]

Any good local pinstriper can do it. I had mine done by a SoCal hot rod guy and he did it on site. He was fast and accrate.

https://www.r18forums.com/threads/pinstriping.610/#post-9028

 

[OzR18]

Any good local pinstriper can do it. I had mine done by a SoCal hot rod guy and he did it on site. He was fast and accrate.

https://www.r18forums.com/threads/pinstriping.610/#post-9028

Love it - That's the kind of thing I had in mind.

Maybe I'm being a bit OCD with trying to match what's already there and the calliper thing.

Thank you