215robert
Active member
Hello, wondering do you have to run resistors or anything of the like if you replace your front turn signals and or rear multi function lights?
-
Welcome to the BMW R18 Forums. Member registration disables ads and allows you to post and share. Register Here.
Led lights and resistors
- Discussion starter 215robert
- Start date
Well, it complicated. I didn't run into any issues after adding my front turn signals.
But I now have a warning light after installing the WalzWerks bobber kit.
And to add to the confusion, another member (Gr8adv) did the WalzWerks bobber kit too and doesn't have a warning light issue. I haven't had a chance to trouble shoot it yet but the two mods together likely pushed things a bit too far.
Bar End Signal Project- Done!
Hey so, I developed a slightly pathological dislike of the stock front turn signals. They never seemed to align perfectly; dangling there like a pair of vestigial appendages and, to make matters more unseemly, the left one often loosened on it's perch. I embarked on a mission to install bar end...
www.r18forums.com
But I now have a warning light after installing the WalzWerks bobber kit.
And to add to the confusion, another member (Gr8adv) did the WalzWerks bobber kit too and doesn't have a warning light issue. I haven't had a chance to trouble shoot it yet but the two mods together likely pushed things a bit too far.
No issue either with my bull eyes turn signals
